We update the Cisco 300-510 exam questions and answers once or twice a month!
All questions and answers are not continuous, because all questions and answers are being updated!
It is impossible for us to update from the first question to a few hundred questions or more. Such an update is definitely not a valid question. So you are lucky! Every update you get here is instant and effective. For all free Cisco certification exam practice questions, please visit: Vcecert.com
The latest update Cisco 300-510 exam dumps has been updated. All exam questions and answers have been verified to ensure that they are true and valid. Get the complete Cisco 300-510 exam dumps in Lead4Pass Cisco CCNP.
You can also directly visit https://www.lead4pass.com/300-510.html (PDF +VCE). Pass the exam 100% successfully.
Cisco 300-510 exam PDF download for free in Google Cloud
Cisco 300-510 exam questions online free test
All free Cisco 300-510 exam practice questions are part of the Lead4Pass 300-510 exam dumps.
You can practice the test online and the exam answers are at the end of the article.
You can also download the 300-510 exam PDF directly to get the free exam questions and Answer.
Assume that the R1 router is enabled for PIM-SM and receives a multicast packet sourced from 172.16.1.100, and the
R1 router has multicast receivers on the Gi0/1, Gi0/2, Gi0/3 and Gi0/4 interfaces.
The multicast packet from the 172.16.1.100 source must arrive on which interface on the R1 router for it to be forwarded
out the other interfaces?
E. Gi0/1 or Gi0/2 or Gi0/3 or Gi0/4
F. Gi0/2 or Gi0/3
G. Gi0/1 or Gi0/4
Refer to the exhibit. P1 and PE3 Cisco IOS XR routers are directly connected and have this configuration applied. The
BGP session is not coming up. Assume that there is no IP reachability problem and both routers can open tcp port 179
to each other.
Which action fixes the issue?
A. Change HMAC-MD5 to HMAC-SHA1-20
B. Configure the send and accept lifetime under key 1
C. Change HMAC-MD5 to MD5
D. Change HMAC-MD5 to HMAC-SHA1-12
Which feature is used in multicast routing to prevent loops?
B. inverse ARP
D. split horizon
Refer to the exhibit. Which statement about this configuration is true?
A. Router 1 sends and receives multiple best paths from neighbor 192.168.1.1
B. Router 1 sends up to two paths to neighbor 192.168.1.1 for all routes
C. Router 1 receives up to two paths from neighbor 192.168.1.1 for all routes in the same AS
D. Router 1 receives only the best path from neighbor 192.168.1.1
Refer to the exhibit. Which task must you perform on interface g1/0/0 to complete the SSM implementation?
A. configure OSPFv3
B. enable CDP
C. disable IGMP
D. configure IGMPv3
Refer to the exhibit. Routers RA and RB are IS-IS peers configured for NSF, but router RC is an IS-IS peer without NSF
capability. If RA undergoes processor switchover, what is the effect on the network environment?
A. If RC is operating without the Cisco configuration option, only 2 routers tear down their peering relationships and reestablish peering
B. All peer relationships remain up, but the link-state database is rebuild on each device
C. If RC is operating without the Cisco configuration option, all three routers tear down their peering relationships and reestablish peering
D. All peer relationships remain up and the link-state database is unchanged
Refer to the exhibit. After troubleshooting an OSPF adjacency issue, routers 1, 2, and 3 have formed OSPF neighbor
relationships. Which statement about the configuration is true?
A. Router 2 receives a Type 5 LSAs from router 1 for its connected subnets
B. Router 2 uses router 3 as the next hop for 192.168.0.0/24
C. Router 2 uses router 1 as the next hop for 192.168.0.0/24
D. Router 2 receives a Type 7 LSAs from router 3 for its connected subnets
After an engineer configures BGP in R1, it starts receiving this message Jun 29 13:30:50.122: %BGP-5-ADJCHANGE:
neighbor 192.168.10.1 Down User reset Jun 29 13:30:52.341: %BGP-3-NOTIFICATION: sent to neighbor 192.168.10.1
2/6 (unacceptable hold time) 0 bytes Which action makes the peering come back up again?
A. Make a soft reset to the peer.
B. Set up a minimum hold-down timer higher.
C. Set up a hello timer higher.
D. Set up a hold-down timer higher.
Which statement about BFD on Cisco IOS XR Software is true?
A. Cisco IOS XR router must use LDP to route back to the Cisco IOS router to establish the peer relationship.
B. Cisco IOS XR Software does not support BFD multihop for IPv4.
C. Cisco IOS XR router must use dynamic routing or a static route back to the Cisco IOS router to establish the peer
D. BFD is not compatible between Cisco IOS XR and Cisco IOS Software.
What must occur before an (S,G) entry can be populated in the multicast routing table?
A. The (*,G) entry must have timed out
B. The (*,G) entry OIL must be null
C. The router must be directly connected to the multicast source
D. The parent (*,G) entry must be created first
Refer to the exhibit. R1 is directly connected to R2 and R3. R1 is in BGP AS 123, R2 is in BGP AS 2, and R3 is in BGP
AS 3. Assume that there is no connectivity issue between R1, R2 and R1, R3. Which result between BGP peers R1, R2
and R1, R3 is true?
A. The BGP session does not come up between R1 and R2 and between R1 and R3.
B. The BGP session comes up between R1 and R2 and between R1 and R3.
C. The BGP session comes up between R1 and R3, but not between R1 and R2.
D. The BGP session comes up between R1 and R2, but not between R1 and R3.
Refer to the exhibit. Which two commands must the engineer configure for the company\\’s PIM-SM network to enable Auto-RP mappings to be sent over the FastEthernet0/0 interface, without affecting normal operation? (Choose two.)
A. enable auto-rp listener
B. enable sparse-mode
C. enable Auto-RP announcements
D. enable sparse-dense mode
E. enable dense mode
A network consultant is troubleshooting IS-IS instances to identify why a routing domains is having communication
problems between the two instances. Which description of the possible cause of issues in the routing domain is true?
A. The same interface cannot be advertised in two different IS-IS instances
B. The IS-IS “ISP” and “ISP2” instances are unrelated and unable to intercommunicate
C. The configured IS-IS NSEL value is not allowing the routing systems to establish a neighborship
D. The interface mode ip router is-is command was not included in the script
A complete Cisco 300-510 exam dumps to help you pass the exam successfully.
To get a complete dumps of the Cisco 300-510 exam, please visit https://www.lead4pass.com/300-510.html (Total Questions: 108 Q&A). Lead4Pass guarantees a smooth pass for the first exam.
Cisco 300-510 exam PDF download for free in Google Cloud